Control Silverstone FM121 with 3 pin fan controller..

Emraith

n00b
Joined
Dec 16, 2006
Messages
37
I bought 3 silverstone FM121 fans(and 2 FM92 fans), they come with their own fan controllers that connect with 2 wires(+ and -, no rpm wire), it has a seperate 3 pin connector(actually only 1 pin, just yellow that sends rpm info to the motherboard/fan controller). I bought a fan controller(sunbeam windmill) that is supposed to control the speed of the fan based on case temp, it connects with 3 pin connections though.

If I connect the 3 pin to the fan controller and the 4 pin power molex, it reads the rpm's just fine, but the fan only spins at 100%. If I also connect the 2 pin controller that came with the fans, I can adjust the rpm's.. What I'm looking for is an adapter that I dont think is even made..

The adapter i need has on 1 end that connects to the fan: 3 pin male connector that has the yellow wire, 2 pin female connector that has red/black, and the other end has 3 pin female connector with the yellow/red/black..

Does anyone know if something like this even exists or how I can do this? Silverstone fans seem to be pretty popular, I wouldnt imagine something like this would be so hard to find..
 
There's probably some trepidation about hacking up his brand new stuff. I know I didn't want to in order to get my 4-pin fans to run at 7v.

The easiest solution is to go through your stuff and try to find some 3-pin to 4-pin adapters. Hack/splice as you need to on them to make your adapter, this way you don't have to cut up your fans but you get the results you need.
 
in that case i suppose that's the only solution ... personally haven't seen such a adapter.
 
ah didnt think about using adapters to modify. But yeah, I really wasnt wanting to cut and splice the wires of the fans themself because I wanted to still be able to use the fan controllers that came with the fan in the future, if i ever needed to. thanks for the suggestions
 
Forget the fan controller just plug it into the 4 pin molex connector, and solder in a 68 ohm resistor in series with the red power wire of the 4 pin Molex connector. You should probable use a 1 watt rated resistor but I used a 1/4 watt and it works just fine.

One little snip, a ten cent resistor and a dab of solder & a strip of electrical tape, and you are good to go. I dropped my 12V 80mm fan down to 5 volts operation with this solution. The fan is inaudible now and still moves plenty of air.

People go so overboard with these "cooling" solutions who needs it.
 
I would like to see a picture of this... that is, with the resistor soldered in. :)
 
I wasnt exactly sure of the cables you were asking for, but here's two kinds that I have (they came like this).

12V to 7V
img2489gs3.jpg



1 wire to fan controller, 2 wires to fan

img2488ju9.jpg
 
Back
Top