Computer silence? Help please=i am scared

note235

Supreme [H]ardness
Joined
May 23, 2005
Messages
5,055
This is my computer
Gigabyte DS3
E6400
3gb DDR2 667
320 Maxtor 7200.10
Evga Geforce 8800gts 320

Now i just bought a new antec 180 case
transfered all the components
This is the updated 1.1 version

now when i press the power switch the pc powers on but the monitor doesnt show a thing
Now the fan does run on the GPU
Im wondering if i should rma the card?
Does the raised motherboard support suppose to be touching the motherboard?
Could that be the problem?
Thanks
 
Normally if something is shorted you won't get fans on or anything, so I doubt it's that, but to be sure pull the motherboard and everything out of the case and set it up on top of the motherboard box (with the card brackets hanging off the edge so the board stays flat). If it works then, check your standoffs in the case and make sure none are installed where they don't match up with a screw hole on the motherboard. You did install the standoffs, right?

GPU or motherboard could be the problem, otherwise. Are you getting any beep codes? Does that board have a diagnostics LED system? (I don't know, I just have a 680i...)

Try with one stick of RAM, and try it in each slot. If that doesn't work try another stick. Could also be RAM.
 
I'd vote ram too. Before I did any RMA'ing i'd reseat everything because things come unhooked in moving computer
 
have you tried to reset the bios, its a stupid problem that happens sometimes.

Make sure u UNPLUG the power cord b4 u do this, replug it and try it again. Good luck.
 
near the bios chip (its a little boxy one, check your manual for where it is) there are 3 pins with a jumper on two of them, just pull the jumper off, and move it to the other pin and one of the ones it was on before, then move it back


thats all you do to reset the bios, are you sure you plugged in the all the cables? you might not have connected that 4 or 8pin processor power connector
 
solved
i did not plug in the 4 pin connector
pc boots and posts now
but my newer one doesnt post?
ill start a new thread
thanks

this one is fixed
 
Congrats.....my Very first build 12 years ago I fought with that machine for hours and it was a screwed up bios but hey glad it was just a cable.
 
Back
Top