Computer restarts twice before I get into windows

Dragon365

Weaksauce
Joined
Jun 17, 2004
Messages
79
Ok, here's what happens: I turn on my computer in the morning, it starts Windows 2000 up to the part before the login screen, and then it restarts. After that restart, it gets to the login screen, I login, and then it restarts again. Both times, the hard drives click off, and there is no blue scrreen. After this, it will run fine all day. Also, I'm not sure when this started, but the bios screen says that my processor should be set down to 1.225 volts (the lowest setting, this is wrong, since the proc needs 1.75 volts.) I planned on replacing the CPU, power supply, and video card (with an XP3000+, GF6800, and Rosewill 450w PS) over Christmas vacation anyways, but are there any other possible problems?

System:
Athlon XP 2100+, Albatron KX400-8x, 1GB Kingston Pc2700 Value Ram, ATI Radeon 9500 Pro, 80 and 40 GB WD hard drives, 400W generic power supply (which has never troubled me before), SB Live, DVD and CD-RW drives. Thank you!
 
I ran a checkdisk on the windows partitions, no problems. I'm going to run a WD Diagnostic and Memtest as soon as the ultimate boot cd is done downloading.
 
Ewww, Rosewill PSU? What are you thinking? That could be the source of the problem. Then again, I think it's the hard disk or simply the fluctuations on the PSU.

-J.
 
GeForceX said:
Ewww, Rosewill PSU? What are you thinking? That could be the source of the problem. Then again, I think it's the hard disk or simply the fluctuations on the PSU.

-J.
Actually it has very good rails and a lot of good reviews on newegg. I was also thinking about one of the Coolmax Taurus models, those seem to get good reviews also.

Edit: also, I fixed the voltage problem by hard resetting the computer after ultimate boot cd locked up (probably because I burned it on a too-quick setting)
 
I have yet to see it on the "Approved" list on [H]'s PSU list in the PSU forums.

-J.
 
Just ran a full WD diagnostic test, no errors were found, so I don't think it's the drive. Hopefully, it was just a bios problem that reset itself when I did the hard reset (my bios has a watch dog timer that resets the settings after a crash/restart.)
 
Try going to your BIOS, set the fail-safe option so it will load the most BASIC bios settings required for it to boot up. Try that. And as usual, unplug/take out your unnecessary components that isn't required for boot up temporarily and test that.

-J.
 
Back
Top