Computer doesn't turn on

IchWill

n00b
Joined
Apr 3, 2005
Messages
45
I purchased a motherboard from the store and a case from newegg. I hooked up the motherboard in the case to what I thought was correct and tried to turn it on and the front LED blinks, all 3 fans spin for about a half second, then it all stops. When I try that again, nothing happens. It only does the blinking and fan thing ONCE unless I reset the switch or unplug and replug it in. I checked the switch hookups a couple times and those are correct. What else could be the problem?
 
I was having the same problem with my Antec Neo480. It wouldn't boot because my RAM was in dual channel mode - a problem I'm having right now. Just make sure everything is hooked up correctly - 12v connector, all hard drives, etc etc.

Then, if it still doesn't boot, I would try to unplug everything but the cpu and hsf. If it boots (cpu fan turns on, etc) then add the RAM, then the vidcard, then the drives, etc. It might help you find the problem

I just thought, also... make sure you hooked up the power switch connectors correctly. It's only a 2-hole connetor, I think, so you may want to try switching it around so it faces the other way. Usually it's something simple like that.

drdeutsch
 
I tried unhooking everything but the power supply to my motherboard, and it still does the exact same thing. I checked the power switch connection and had someone double check it and it is correct. I'm lost. Is my power supply shot?
 
When you have the psu hooked up just to the mobo, you do have the 20-pin 12v connector and the 4-pin square one connected, right? You'll need both of those connected.

If you still get nothing, I would look at getting a new psu. The reviews on Newegg mention the generic psu as being not so good (or at least not desirable).
 
i had a similar problem when i used a cpu fan w/ only two wires instead of three on an abit board, the bios wanted a 3 wire cpu fan, the yellow wire is for speed detection and if the board didnt detect that a fan was moving it wouldnt power up
 
I just connected the my PSU to an old motherboard I had laying around, and I got it to boot. Shitty motherboard...
 
pstang said:
i had a similar problem when i used a cpu fan w/ only two wires instead of three on an abit board, the bios wanted a 3 wire cpu fan, the yellow wire is for speed detection and if the board didnt detect that a fan was moving it wouldnt power up
Actually, I don't even have a fan hooked up to the motherboard. The case came with 3 fans (1 HD fan, 1 PSU, and 1 on the side) and they are all hooked to the power supply and not as a system fan. Maybe this is the problem.
 
if the board is new take it back and get a new one, i have never used an ecs mobo, abit, asus, and msi have always been good boards for me
 
I had EXACTLY the same "symptoms" on my previous system. The blinking light (power LED) means your PC has gone into sleep mode. With my previous system, if I unplugged it for any reason, and then plugged it back in, the power LED would blink, the fans would kick in for a second or so and then stop. At this point, instead of unplugging, try holding the power switch for 4 or 5 seconds. This takes the PC out of sleep mode. In other words you dont have to unplug to get it to start up. I dont know if these symptoms are always linked to PSU problems, but when I changed my PSU the problem was solved. You dont have a spare PSU lying around do you? By the way, why did you change the mobo in the first place? Were you getting rapid reboots by any chance?
 
I figured out the problem: my motherboard was touching the case so I fixed it and it works fine now. Thanks for the help.
 
Back
Top