Compaq SR-series case problem . . .

Joined
Feb 19, 2004
Messages
3,861
Hiya, I recently came across a mATX SR-series case from Compaq. It came completely stripped and I'm having some issues getting the drives to seat correctly. It uses some stupid "latch" method to hold the drives in. From what I've managed to figure out you have to screw in these screw thingies and then jam the drive into the cage until the green thingies snap and hold it in. This seems all fine and good but it doesn't hold everything in very securely, especially the HDD, which is free to jiggle around. So I'm wondering if I'm missing something, drive-rails perhaps? Anybody have experience with these cases and know something I don't? I've done a whole bunch of googling and searching eBay for parts without much luck.

Here are some pictures of my case in it's current state:

Note the big stupid green latching mechanism thingy:

Here's a shot of the screw thingies:


Here's a link to HP's very helpful "How to install a HDD" page:
http://h10025.www1.hp.com/ewfrf/wc/...&product=89327&dlc=en&docname=bph03429#N10021

Here is a link to some drive-rails on eBay, I'm not positive that they are for this case, though:
http://cgi.ebay.com/COMPAQ-143856-0...ryZ42305QQssPageNameZWD1VQQrdZ1QQcmdZViewItem

Any help would be appreciated. I was thinking about jamming some silicone washers in between the drive cage and the HDD to keep it secure. Also because of the locking mechanism I can only get one screw in on one side of my fan controller. :(

I was going to post this in the case-modding forums but I thought you guys would have more experience dealing with these types of cases.
Thanks,

 
As an eBay Associate, HardForum may earn from qualifying purchases.
edit: are you using screws with the right thread size?

The drives should be secure, but might wobble a small bit. I used to have a SR1010Z and didn't think anything was wrong with the hard drive mounting.
 
The case came with a bunch of screws screwed into the front behind the bezel. I assume they are for mounting drives. They seem to be of the correct thread size as they fit into the HDD and CD-ROM fine without incident.
 
anybody else have ideas? is the latching mechanism supposed to allow a little play? maybe I'll just jam some rubber washers in there or something, I just hate to be that ghetto. I may just take all the rivets out so I can get to the other side of the drive cage and see about a better fastening method.

Thanks,


 
Are the screws black with rectangular heads? That is, instead of the dome most screws have? They are supposed to catch behind the green levers, so it looks like you've got it right. My roomie has an SR1050NX, except that he gave me the case when he migrated to a Super Lanboy. IIRC, there can be a tiny bit of play in the drives, but nothing to panic over.
 
Yeah, I had the same problem, the hard drive, CD-Rom drives just would not stay secure in that case. I hated that case and dumped it for a $17 case.
 
okay, thanks for letting me know I'm not stupid and/or crazy. I'm prolly just going to take the thing apart and see what I can come up with to make it secure. This thing is going to be sitting in my living room once I get my new HDTV for xmas, I do not want to be listening to the HDD rattle in the cage while I'm watching german midget porn . . . I mean, ummmm, Harry Potter.

 
Back
Top