Compaq Power Supply (Replacing the Fan)

Format _C:

Supreme [H]ardness
2FA
Joined
Jun 12, 2001
Messages
4,207
A friend gave me an old Compaq Deskpro PIII 600 MHZ 384MB Ram 0GB HDD (Unsure of the model as I don't know which set of #s is the model and I got it because I built him a new computer with spare parts I had around the house:D) but anyway the PSU fan is dead and I am aware that the stock fan has a fan controller circuit how so I bypass that? As I just cut the wires from the old fan off and soldered another fans wires to it. I think I need to bypass the fan controller circuit because the new fan will twitch the blades when I turn on the computer but will not spin no matter how hot the PSU gets and the psu was getting so hot that the casing was too hot for me to hold my hand on for any length of time after about 10 Mins of use (I was just running Memtest 86 as it has no hard drive I have to get one, so not exactly running stressing tasks) I know I could just run the fan wire to a free molex but I rather not do that if there is a more proper or better way
Thanks
Oh the old fan was a Nidec Beta V and I confirmed it dead by connecting it to a 12V supply and the replacement is a top motor and the fan is 80MM
 
How many pins did the fan connect to the board with? If just two, you'll need to find a different place to get power from. Probably easiest to just run the wires out of the PSU to a molex, but if you take the PSU out of its case you should be able to find and tap the 12V rail directly.
 
The fan only had two wires connected to another little PCB with a thermometer (thermistor) on it mounted to the heat sink and that board had two wire going to the main PSU board (Red/Black The fans wires were blue/red
 
The fan only had two wires connected to another little PCB with a thermometer (thermistor) on it mounted to the heat sink and that board had two wire going to the main PSU board (Red/Black The fans wires were blue/red

Those lines back to the PSU are probably just 12V power. I'd just try it. Otherwise just pull the 12V off at the PSU output.
 
Ok that worked and the fan spins at full speed now so the PSU will stay cool
Thanks
 
Back
Top