comp won't post with new ram install

Do you have the dimm in the correct slot for single channel mode? Some motherboards force you to put a dimm in a particular slot when you are using single channel mode.

Also in the future never buy a board from ECS.
 
yes

I tried both slots with 1 each and with both

same results.
 
Are the voltages for the ram set correctly? How about the timing?
I never messed with a htpc setup before but i believe that this would still play a factor in ram compatibility.
 
Not too sure since the pc won't post at all

Screen stays black and i hear long beeps
 
I took the mobo out of case and put everything together outside the case

Same issue....nothing on the screen...long beeps


Tried 2 other sticks of ram

Same issue

Is the motherboard fried?


If so, can it be replaced for <$60?

Specs are

amd brisbane 4000+
2 gig of pc26400 ram
3 hd's
430w antec psu
9600gt

I do have a e5200 in the stash...should i now get an intel board? or stick with amd since money is low?
 
You can get a motherboard for either under $50. There are 34 AMD boards at newegg under $50. Most of these appear to be compatible.

There is also 28 Intel socket 775 boards for less than $50 at newegg.
 
I don't buy boards in this price range so I do not have experience with any of them. I would check the ratings.
 
Tried that...nothing

what's irking me is NEITHER stick works. it's like the old stick died once i put the new one in,

this is how it went down

I got the extra stick in the mail this afternoon
i powered down
grounded myself
opened up the case
popped the extra stick in the empty dimm slot
powered on.....nothing on the screen...long continuous beeps.
took the stick out...powered on...nothing on the screen...long beeps.

Took the old stick out, put the new stick in the first slot, same applies.

Then tried each stick in each slot together and by themselves...same applies.
 
The non-standard voltage of the new dimm could have destroyed the old dimm. DDR2 voltage is supposed to be 1.8V anything more than that is non-standard.
 
Searching ECS's website for the motherboard post codes is as useless as their motherboards.... Each time I did a search, it returned me to the main page.

My suggestions would be the following:
Remove any peripherals that aren't needed to boot.
Remove ALL RAM from the motherboard.
Power on the computer. You should receive a different post code (which I believe should be a single beep). Power computer off.
Add the old stick of memory. Power computer on. If you continue to receive the continuous long beeps, power off, disconnect power from the motherboard, and reset the bios/cmos using the jumper.
Start process over and see what happens.
 
Looks fine and it is from a manufacturer I would recommend. GIGABYTE, ASUS, EVGA, Intel, Tyan and SuperMicro are the brands I recommend.
 
Looks fine and it is from a manufacturer I would recommend. GIGABYTE, ASUS, EVGA, Intel, Tyan and SuperMicro are the brands I recommend.

Not bad, my personal favorites would be Supermicro and a distant second and third Intel and Gigabyte. Is tyan still around? Liked them too long ago.


For the OP on clearing the CMOS I like to pull the battery, remove power from the board and shorting the clear CMOS jumper for a good five minutes, sometimes they are just stubborn but sounds like your at that point where you need something else.
 
Is tyan still around?

They still have the web page. I admit that the the last Tyan board I purchased was a dual processor socket 940 opteron board and that was sometime in 2007.
 
Back
Top