Commando CPU INIT.. possibly not enough power?

GEN3RIC

Limp Gawd
Joined
Feb 22, 2007
Messages
174
Ive got some concerns. All of my parts are here and upon finishing my build I realize that my PSU has only a 20pin 12v and that doesn't quite add up to the 24-pin on my Commando, as well as the 1x4+4pin by the CPU.

I have only enough cabling for 1-4pin and 20pin 12v.. Some people say that's enough.. but when I go to start on my PC I get NO fans and the LCD POSTer says CPU INIT.

Should I go buy a PSU with 1x4+4 and 1x24pin? My wattage is 500W and its a guaranteed good PSU.

I've seated and reseated the memory and CPU.. seems to be no issues at all! And Ive only got some DDR400 184 pin otherwise so I cant test that. Bugger.

What on earth is the deal?
 
Many mobos will detect whether you've plugged in the required 24-pin + 8-pin connector
I would try a new power supply, perhaps buy one locally so you can easily return it if that doesn't turn out to be the problem?
 
Hmm.. I completely dissassembled everything, then decided to retry it. I reseated everything, set up all the power cables.. I think its possible the 4-pin wasn't well connected, because it works fine now.


Now I am just worried about my voltages - PC Probe II is giving me warning bells about my Vcore and SB Vcore. (1.16 and 3.57) those values seem normal considering I left EIST on.. everything is on AUTO right now.

I am going to change that since I know what should work..
 
my temporary solution is an ULTRA Xconnect 500W modular. It seems to be working fine... my 3-5-12 rails are all +/-0.1v.

My new PSU will be here soon I hope...
 
i have the asus crosshair with the lcd poster as well.. when the pc is turned off the little screen says cpu init all the time.. when i press power everything starts up fine no issues at all, pc probe2 has green for everything

probly wouldnt hurt to pick up a proper psu
i have the corsair 620w and its great.. depending on your specs the 520w is great too for a bit cheaper
 
Back
Top