CMOS reset - remove all other components?

Flogger23m

Fully [H]
Joined
Jun 19, 2009
Messages
17,030
I am wondering if I were to reset the CMOS on the motherboard, should I remove/unplug all components connecting to the motherboard?

And is switching the jumpers good enough or do you also have to physically pull the battery out?

And since this will reset all of my settings what should I note before clearing the CMOS? I am thinking RAM settings (though I never OCed, so these should be the defaults) and disabling the fan speed warning for the CPU (as my fan can spin low enough to trigger the warning). Aside from this I can not think of anything else that I should note?

Thanks in advance.
 
If you didnt change anything before, dont worry about how its set, it will auto detect.
Jumper is fine. Best to pull ethernet and power cord at least to make sure its got no power.
Otherwise no need to strip it to bare board
 
Thanks for the reply. The only thing I changed that I can recall was the CPU fan warning (disabled) and Cool N Quiet (disabled). But those are simple enough to reset even if not autodetected.
 
Back
Top