Chaintech VNF4 northbridge cooling issues

grenadier

Limp Gawd
Joined
May 5, 2002
Messages
494
I've heard that the passive northbridge heatsink that comes with this motherboard just doesn't do a good enough job to safely overclock your board. Heck in one of the reviews I read (can't find the link) after getting it up to 300fsb they actually fried the motherboard. I picked up one of the massive zalman chipset coolers just to be safe when I bought the rest of the system (VNF4 + 3000+). The link is below. Do you think this will be enough to keep my board safe if I can hit 250-300 fsb speeds?

http://www.newegg.com/app/ViewProductDesc.asp?description=35-118-214&depa=0
 
just make sure u have decent airflow over it. Maybe ad a temp controlled fan so once it reaches a certain point it kicks in, that way u wouldnt deal with the noise all the time.
 
I' m using a Freezer 64 with the fan blowing upwards to cool the processor so hopefully it will pull some air over the chipset heatsink even though it won't be blowing directly onto it.

After thinking about it for a while since the VNF4 has it's northbridge where most motherboards have their videocard slots my side casefan might also be blowing directly onto the chipset heatsink. Hopefully it ends up working out this way.
 
Just got my VNF4 and the heatsink on it is still passive, but is larger than the one shown in the VNF4 reviews floating around the web.

Figured I might as well swap it for the larger zalman northbridge heatsink I got anyways since I already bought it. I would have had to take off the original heatsink no matter what to slip some AS5 under there so installing the zalman cooler wasn't too bad. The installation mechanism on this thing is terrible though! Took me like twenty minutes to get the damn pins lined up right. I'll post overclocking results after my memory shows up in the mail tomorrow.
 
Replaced the original heatsink with the zalman northbridge cooler and some AS5. The northbridge on this thing runs HOT! Like I can barely touch the northbridge heatsink hot. It ran stable under load all night though so it doesn't to be much of a problem, but sheesh... this can't be good for the life of the board.
 
Back
Top