Ceramique application

[Expe]

Using the guide from the arctic silver site.

Does that look alright?


I notice my temps can vary between the two cores about 5C while idle and 3C while under Orthos full load. Could that be because I put a little too much on the top? Or is that normal?

Pic of idle temps


Using scythe ninja rev B on e6300.

Thanks

 

[jcll2002]

the difference in temps on one core to another is normal. I apply differently, like the size of a grain or rice (or even alittle less). Im sure thats fine though.

 

[kill4killin]

Application technique is pretty much personal preference the only thing that really matters is that you cover the die with a very thin layer. Personally, I prefer to cover the full IHS or die with a very thin layer and then a small dab in the middle of the IHS to make sure that the die gets any air bubbles out of the contact.

 

[_Korruption_]

That looks like a good amount.

 

[Expe]

Thanks for the feedback, temps are peaking at 53C after a while of load as i type this. I'm fairly satisfied.