![[H]ard|Forum](/styles/hardforum/xenforo/logo_dark.png){kind=logo}
I'm trying to set up Etherchannels for our Proliant DL380s with LACP. Using HP's networking configurator I set the two interfaces to a team with the type as "Automatic (Recommended)". Here are my options
Then I go onto our switch and set up the port like so..
So did I do this right? Just wanting to make sure before I turn the team on and break stuff
Code:
Automatic (Recommended)
802.3ad Dynamic with Fault Tolerance
Switch-assisted Load balancing with Fault Tolerance (SLB)
Transmit Load Balancing with Fault Tolerance (TLB)
Transmit Load Balancing with Fault Tolerance and Preference Order
Network Fault Tolerance Only (NFT)
Network Fault Tolerance Only with Preference OrderThen I go onto our switch and set up the port like so..
Code:
interface FastEthernet0/47
switchport mode access
channel-group 1 mode passive
spanning-tree portfast
!
interface FastEthernet0/48
switchport mode access
channel-group 1 mode active
spanning-tree portfast
!So did I do this right? Just wanting to make sure before I turn the team on and break stuff