Can't get Q9550 to work with IP35-E

Joined
Feb 2, 2007
Messages
932
I updated to the version 18 BIOS already and it won't post. So after some research I found a 18 beta from 9/2008 that supposedly has support for E0 stepping (which mine is). That didn't work either, so I went back to the version 15 that is listed as being compatible on the Abit site. Strike 3.

It's a brand new chip, so I refuse to believe it's dead. I've seen tons of success stories with the IP35-E, so it's hard to accept that it won't work with my board. Help.
 
No, and I'm on my 3rd or 4th flash now. I bought a used P5Q SE Plus off these forums, so hopefully I'll have better luck with that.
 
Have you re-tried your E4300 in the mobo? This would ensure it's not a bad flash. Also make sure all the power connectors are plugged in. The IP35-E also requires a molex power connector. I'm not doubting you, I just want to rule out the obvious. Keep us posted.
 
This happened to me EXACTLY. I had an ip35-e with an e6750, tried popping in a q9550 and no boot... Tried a bunch of different bios versions, even some beta one I found on hexus. Had to end up getting a new mobo.
 
Back
Top