Cant boot off my SATA RAID card

  • Thread starter Deleted member 19858
  • Start date
D

Deleted member 19858

Guest
I just installed Windows 2003 server on 2 400GB hard drives setup as a RAID 1 array. The installation went fine however when it went to reboot and run Windows it isnt finding the drives. I am using an Adaptec 12120SA which has a bootable ROM so that shouldnt be the problem. In the motherboard BIOS I have the first boot drive set to SCSI so it should find the card. The motherboard is an ECS D6VAA without onboard RAID and is running with the newest BIOS.

I checked on Adaptec's website to find out how to make the array bootable and it is setup correctly. Is there something I am missing because I really wanna get this server going.

Basically once I get Windows installed it reboots to continue the process, once it gets to where it will boot from the first device as specified in the motherboard BIOS the screen just goes black and nothing happens.
 
are there any other controllers higher in the PIRQ routing?
(In which case switching the PCI slot would be the easy answer )
 
Nope, only PCI I have right now are the SATA controller, 56k modem, gigabit NIC, and video card.
 
Back
Top