Can I damage my components? What should I avoid

jweller13

n00b
Joined
Jul 14, 2006
Messages
33
New to overclocking.

Are there any overclocking changes I might make that have the potential of damaging my memory, motherboard, or graphics card? If so how do I judge the damage threshhold so I don't step over it.

--Evga 680i
--OCZ 800MHz DDR2/EPP 4-4-4-15 1T/(2x1024/2.1 Volts)
--Evga 8800xts
--E6700
--850W PSU
--Standard cooling on all
--onboard audio
 
Just don't add too much voltage, and make sure you don't let stuff overheat.
 
Did you put it together yet?

Why are you using the STOCK intel heatsink if you want to overclock?

1: Set your RAM to the advertised or manufacturer's recommended settings.

1.55V should be the very maximum for your CPU.

And make sure your Load temperatures are under 70c. (You cannot do this with the stock cooler)

With Dual Core CPU's, you need to use Orthos to test for stability. Same as prime 95, except that orthos loads both cores at once.

Disable all spectrum settings, C1E, Speedstep, Thermal Control and GPU EX.

Set your FSB to 1.4V

Set your FSB to 1200mhz and your RAM to linked (600mhz) = 3.0ghz

RAM to (ABOVE)

CPU Vcore to 1.35V

All other voltages can remain as AUTO.

Test for @ least 1 hour with Orthos (Small TEST)

If it passes, reduce the CPU Voltage to 1.34 or 1.33 and test again.

Watch your temperatures
 
cpu vcore voltage and RAM voltage are the only things you should have to adjust, everything else on this board works fine in auto. don't go over 2.2v on the RAM without active cooling and don't go past much more than 1.5v for the cpu vcore.
 
Back
Top