Cable management, how good/bad am I doing?

ap3rtis

Limp Gawd
Joined
Dec 26, 2006
Messages
232
Picture014.jpg

Picture015.jpg

Picture016.jpg

Picture017.jpg


The two cables loose at the top are for the fans. For reference the parts are:
xfi xtreme music
x1950pro
floppy
dvd drive
965p-ds3

I still have to connect the harddrive at the bottom, and hook up the fans.
Is it ok to have the cables resting on the video card like that?
Also, to hook up the fan at the bottom, is it ok to just hook it straight into a 4-pin connecter that branches from another cable? or is that too much power? I only ask because the ones at the top have a connecter that says FAN ONLY.
 
It's "ok"...

I've seen worse but also much better. Try either using rounded ide cables or better fold the ide cables and tape them to the case. Also try (if possible) routing your psu cables a little different and zip-tie them.

Try putting every lose cable together in a bundle and zip tie them together, maybe even to the case on the side somewhere.

Sometimes it's hard to hide cables and that's the best you can do with what you have, but i'd try to at least fold the ide cables.

Other than that, cables resting on a card is usually not a problem unless the card gets so hot that it'd melt the cable housing.
 
I cleaned it a little bit, folded up the FDD cable (IDE didn't have enough slack), and used twist ties all over the place to keep cables together. Good news is it turns on :D Formatting hard drive right now (320GB) :(
 
shit, the cpu power cable was touching the cpu fan, I didn't notice it, but I did notice something was making a funny buzzing noise in the case. It was the cpu fan trying to start. All I am doing right now is installing windows (formatting harddrive at the moment), so my cpu should be ok right? The fan went pretty crazy at the start, but now it's slowing down. I can't believe I missed that, I could of sworn it was running when I started it, the cable must of brushed it. Also I had the two big 120mm fans at the top sucking air out, and it didn't feel hot at all, so my cpu should be fine right? cpu is e6400.
 
shit, the cpu power cable was touching the cpu fan, .

That's an obvious layout problem based on the pic. It's hard to tell from the photo, but do you have enough length in the power cables to run them anti-clockwise around the MB instead of over the top? You should keep them off the MB and definitely away from any fan.

BTW - connecting a fan directly to a 4 pin Molex is fine if it has the connector. That means it will run full speed only (the "fan only" power lines might be speed controlled).
 
ya, there really isn't enough length for it. I'm pretty sure I tried and am sure over the top is the only way.Do you think my cpu should be fine though?
 
Back
Top