C2D Build and cannot boot from cd on a new build

Joined
Dec 14, 2006
Messages
3
ovk, put together a new c2d build but I can't get it to book from my CD drive...

cd is the first boot device in the cmos. its a gigabyte DS3 board, cd is #1 device followed by floppy and then HDD. upon booting, it says "boot from cd/dvd" but doesnt do anything from there (with the winXP install cd in the drive obviously). what am I doing wrong? its the only IDE drive installed (HDD is sata). usually on new builds im used to the normal blue screen XP installation setup, but this time around it just hangs. any suggestions?
discounteggroll is online now
# Edit/Delete MessageEdit
# Reply With QuoteReply
# Quick reply to this message
 
Back
Top