building new plexi case. opinion needed

[Randolf]

so I'm building a new plexi case for my htpc. I'm aiming to build it with as few joints as possible. but I made a slight booboo.

the front side peice is about a inch short on each end. now I can either cut the top and base to fit it. or I can cut another front/side peice and redo allowing for 3 or so inches of over hang then trim back to fit. I'm leaning towards maybe doing it again. but I also like the idea of the board fitting the case almost exact.

so give me your ideas and feedback

 

[Randolf]

anyone?

 

[incomudro]

as long as you dont put lights init looks fine to me as for the whole problem issue u have me lost

 

[Randolf]

orginally designed the case to be longer. now I can either redo the panel or shorten the case