Boot Loop on 2600K & P67A-UD3

Ur_Mom

Fully [H]
Joined
May 15, 2006
Messages
20,918
I have a new Sandy Bridge setup that is giving me some serious problems. I can't boot. At all. The fans start up for ~2-3 seconds then power off. Then on again. This repeats indefinitely. Can't get into BIOS. No beeps. Nothing.

What I've done so far:

Cleared CMOS.
Tried board outside of case with minimal components.
Tried different RAM.
Tried another board (same make and model).
Checked CPU in a different PC, works fine.
Heatsink is seated correctly, reapplied thermal paste, etc...

The ONLY thing I haven't done was try a different PSU. I'm using an OCZ 700w model that utilizes the 8 pin 12V plug and the 24 pin ATX plug. The PSU works great in a Core2Duo machine I have right now with everything plugged in. I figured if it was a power problem, it would show when I didn't have anything plugged into PSU vs. a full load.

I've Googled this, and it seems like a common problem, but no solution. Some it's the PSU, others it's something else... I'm stumped. Anyone have a similar problem? Any suggestions? If I replace the PSU, any recommendations on a sub-$100 GOOD PSU?
 
Can you check if there is a dirt under your cpu processors?
I have this P67A-UD3 (bios F6) and it is without any problem using Intel I5 2600K.
Here is my system configuration:
Motherboard: P67A-UD3
Bios version: F6
CPU: Intel I5 2600K
Memory: Kingmax DDR3 1333 FSB (2 GB) in dual channel.
OS: Window 7 64 bits.
 
I reason I ask you to check is this happen to me before,
The system will not boot, but after checking the cpu bottom surface, I see some small dirt like dry heat paste under the gold plated on my processor.
 
No dirt. Brand new. I'll clean it up and try it again, though. At this point, I'm willing to try anything! :)

Thanks for the suggestion!
 
I see, did you have any add on card attached on your motherboard?
If so, try to remove it to check.
And also I guess you should have RMA your motherboard to check. Thanks.
 
my p67 board will do this if it doesn't like the memory that's installed. it will also do this if spread spectrum is disabled in the bios. there's actually a couple of things that cause that.
 
I had the problem on 2 p67-gd65's, on one I moved the 2 mem sticks from 1-3 to 2-4 slots and it worked. Was working at one time in 1-3, no other changes, no overclock, and spread spectrum disabled. Just a hunch, but UEFI seems buggy for me, get the double boot (makes me flinch and hold my breath,worried about boot-loop). Haven't reversed it to check if the slots are bad, SO just my unfounded opinion that it might be UEFI.
 
Back
Top