Blue screen on os install new hardware

xavierq

Gawd
Joined
Jul 27, 2000
Messages
562
Got my RAM for my Retail Edge kit. Two sticks of Mushkin 25MB DDR Level II Cas2. Board's an Intel, chip's a P4 3.0Ghz, in case you're not familiar with Retail Edge.

I can not get Windows to install no matter what I do. I tried XP and 2000. I get a blue screen either during the setup file copy, or during the reboot after the copy. Either "IRQL NOT LESS THAN OR EQUAL" or "PAGE FAULT IN NONPAGED AREA" though I get some with no names listed. I tried a diff HD, tried reformatting both quick and regular, repartitioning, changed the vid card, moved the RAM, changed the PSU, changed the CDROM., changed the cables. Nothing helps. I'm out of ideas. I'm about to say either the MB, cpu, or RAM is bad. Anyone have anything else I can try, or any insight on the problem?
 
You're not overclocking are you?

Did you do a MemTest86? Do you have another board that the RAM works in...
 
Try loosening the memory timings. I know the chips are rated for CAS 2, but sometimes they just won't run there reliably. Try them at CAS 2.5 or CAS 3 to install the OS, and see if that works. This was the cure for my new AMD board...
 
Not OCing... this is all stock out of the box. (well, except for the ghetto thermal pad. Replaced that shit asap) hadn't thought to lower the RAM timings. Used to by SPD being as low as it goes. Will manually lower them to 2.5 or 3.... What timings should I be setting it to for that? 2336?

Oh, and on my latest attempt, it told me it couldn't copy a file. I hit retry repeatedly to no avail. I'd say the HD was being ghey, but I already tried changing HD's... CD's brand new, and I've switched drives already.
 
yeah lowering the ram timings worked, we got xp instaled (XQ is on the other side of the room doing updates)

will he have to keep the timeings down and thats it, or is there a way to up them later (if he has to stick to the timings he is running now it was kinda a waste of cash to get the ram he did)

thanks for the replys
 
You have to bump up the voltage.

My Mushkin Level II couldn't do 2-2-2-6 at the voltage of 2.55 I think, bumped it up to 2.6, it ran at 2-3-2-6. A higher bump and I had it running at 2-2-2-6.
 
How can they sell RAM based on timings that aren't possible without a voltage bump?

And can I even do that on an Intel board?
 
Back
Top