BioStar "M7NCG 400" Speed Problems?

Joined
Feb 29, 2004
Messages
9
Building my first whole setup with this mATX board. Only problem is I can't get it to run at full speed. It's running my 2500+ at like 1100. Whenever I go into bios and change it works fine until I reboot then goes back to old setting. There is very poor documentation with this board. I think I'm supposed to remove the JCLK3 jumper but it doesnt appear to be there, its just like a looped wire. It runs fine at 2500+ and even 3200+, but i cant get it to stay there. Forgive me if this is a stupid question, I'm just hoping someone can tell me what I'm doing wrong, otherwise I'll just call up BioStar Monday. Thanks guys.
 
there's most likely a jumper to set the default fsb on the mobo

look for it, it probably has 3 pins and is around where the cpu socket is.

just change the jumper.

i'm not 100 % sure, but hope this helps.

good luck
 
ok, if the bios is like mine, (m7ncd pro) you can set the way the cpu is identified from auto to expert - see if that helps - Also, it could be your cmos battery is dead ( get replacement at Radio Shack)
Another thing to try - clear cmos & start over - if no go then do a "deep" clear - unplug the system, turn on the system ( to get rid of charge), then switch the cmos jumper to clear, then take out the cmos battery - for thirty minutes -set everything back & boot to see if there is any difference.
And yet another thing to try is download the newest bios from biostar and load it - see if that helps...
IF the bios clears more than just your cpu - then it prolly is the battery.
 
Back
Top