BIOS flash via CD??

easykill

n00b
Joined
Nov 3, 2004
Messages
3
I searched, but no luck.

Is it possible to flash the BIOS on a MSI K8N Neo2 Platinum board via booting from CD-ROM?? I don't have a floppy drive in it, and it would be annoying to dig one up to do it. I guess I could though.

Thanks.
 
I've never done it but it seems like it would work.

Make a bootable CD ( http://www.bootdisk.com/ ) and throw your flash utility and BIOS on it. Run the utility when you get a command prompt.

The only problem I can foresee is if the flash utility tries to write to the drive where it's located, like to create a log entry of the flash or something.

Your board doesn't support a windows flash program? (although they aren't ideal)
 
I used to use a bootable cd all the time until the windows flash utilities came out. Just make a bootable cd using whatever method you prefer and put on all the files needed to update the bios. I have never had any errors about log files or anything like that. I also feel a lot safer flashing the bios from something like a cd over a floppy disk. :)
 
RawsonDR said:
I've never done it but it seems like it would work.

Make a bootable CD ( http://www.bootdisk.com/ ) and throw your flash utility and BIOS on it. Run the utility when you get a command prompt.

The only problem I can foresee is if the flash utility tries to write to the drive where it's located, like to create a log entry of the flash or something.

Your board doesn't support a windows flash program? (although they aren't ideal)

It works, in fact you can make a boot disk and put all of the latest drivers, bios, flasher, utilities, etc onto the CDR, makes a good troubleshooting or setup disk too.

MD
 
MD_Willington said:
It works, in fact you can make a boot disk and put all of the latest drivers, bios, flasher, utilities, etc onto the CDR, makes a good troubleshooting or setup disk too.

MD

Seconded. It works like a charm. For a howto, this is brief, full of holes and from memory:

Start up Nero (classic mode/non Nero-Express) and start a new compilation

From the left column, scroll down and select CD (boot). On the "boot" tab, pick your image file you want if you dislike Nero's boot disk image (default works fine). Uncheck the expert options, you dont need them for your first disk. click "new" to proceed to adding files.

Drag/drop your files you want, flash utils, roms, etc and click burn.

REboot and you're now in DOS mode at an A:\ prompt. The files you have burned are on the cd-drive letter (D, e, f, etc) that you see in windows. You can now run those flash utils from the command prompt. Easier and quicker than a floppy, but nowhere near as quick as the more modern windows flash utils.

Note: if using NTFS, you wont be able to do a whole lot with the nero boot image, you need another one, but for flashing bios/firmwares, this works fine.
 
it wouldnt work w/ cd boot so i tryed usnin winflash and when i go to open the .bin it says file's Bios- lock string does not match your system... can anyone help me out here i went to fic which is my boards manafactuer and downloaded the latest version of the bios for my board wich is an fic am37
 
Back
Top