GJSNeptune
[H]F Junkie
- Joined
- Mar 31, 2004
- Messages
- 12,372
This morning my dad installed some Olympus software that he got with his new camera (SP-550UZ). He said that it asked something about changing or reconfiguring his virtual memory. After installation it rebooted, and he said the software worked fine and stuff. I'm not sure if it rebooted randomly or if he rebooted for some reason, but there's no motherboard beep when the computer is turned on, and the monitor doesn't indicate a signal. Everything starts up. The optical drive, the hard drive, the case fans.
He has an old Celeron with an Asus P4P800-VM, a Radeon 7000, and 256MB of PC133 RAM. I've reseated his RAM stick, the video card, reset CMOS, tried it with onboard video, and still nothing. I turn on the computer, everything runs, but no beep like my dad's used to hearing.
My ultimate fix is to backup his hard drive and basically run it on my old AthlonXP rig. Just wondering if there's any hope for avoiding the hassle.
He has an old Celeron with an Asus P4P800-VM, a Radeon 7000, and 256MB of PC133 RAM. I've reseated his RAM stick, the video card, reset CMOS, tried it with onboard video, and still nothing. I turn on the computer, everything runs, but no beep like my dad's used to hearing.
My ultimate fix is to backup his hard drive and basically run it on my old AthlonXP rig. Just wondering if there's any hope for avoiding the hassle.