Just finished assembling a new system and it looks like the board is crapping out.
Board is a shuttle mn31n. AXP 1800+, 512MB RAM, radeon AGP card. I tried to boot with integrated video and didn't get any signal, so I installed the vid card. The following error message comes up:
BIOS BootBlock error
Detecting drive A:
Error Detecting Drive A, System Halt
(or something like that).
Any ideas on how to fix it? I didn't do anything to the board other than just installing it. I've tried resetting the CMOS both via jumper and via the "Hold insert and press power" method, but it didn't help. I have a feeling that I need a floppy drive to flash the BIOS but there's one problem: The case is an antec Aria and there's NO FLOPPY CONNECTOR! Plus I'd rather not have to flash the BIOS if I don't have to.
Board is a shuttle mn31n. AXP 1800+, 512MB RAM, radeon AGP card. I tried to boot with integrated video and didn't get any signal, so I installed the vid card. The following error message comes up:
BIOS BootBlock error
Detecting drive A:
Error Detecting Drive A, System Halt
(or something like that).
Any ideas on how to fix it? I didn't do anything to the board other than just installing it. I've tried resetting the CMOS both via jumper and via the "Hold insert and press power" method, but it didn't help. I have a feeling that I need a floppy drive to flash the BIOS but there's one problem: The case is an antec Aria and there's NO FLOPPY CONNECTOR! Plus I'd rather not have to flash the BIOS if I don't have to.