Bad Axe 2 error codes?

janitor53

Weaksauce
Joined
May 23, 2005
Messages
85
Just finished a badaxe2 6600 build and when loading I notice some letters/numbers in the bottom right corner. I've heard mention that these could be error codes, does anyone have any insight on this?
 
I thought this was normal. Mine does it too... I see no evidence of errors...
 
Ok, back the truck up. I'm not saying I'm right :)

I hope I am!
 
I see them too on my BX2. I noticed they change as soon as I hit F2 to get into the BIOS.

I figured the two characters were something along the lines of a byte that represented the current loading configuration. Hitting F changes the byte from "Boot normally" to "Load BOIS screen". I am, of course, pulling this out of my ass.
 
You know, this is really my only complaint about this board. The documentation.

The manual is pretty, well done, and gets you through _basic_ installation quite nicely.

But then it all stops. No BIOS information (and the PDF on Intel's site is a mashup of all their BIOS's), or other technical information.

I wish there was a FAQ dedicated to this board.
 
These are not error codes but rather called POST codes. (Power On Self Test)
They are status indications of what the system is doing while starting up at the BIOS level.
They can be used to diag issues if say it hangs at a certain point during boot - you could google the POST code to determin if say is stopped while checking memory or there was an issue with a PCI card. Many of them stand for very low level operations.

You should read http://en.wikipedia.org/wiki/Power-on_self-test for much more detail.

I remember back in the day you had to buy a special ISA or PCI card with a little 2 digit display on it that would would plug into the PC so that you could get these codes to determin why the system was not booting. Displaying them on screen makes alot of tech's life easyer.
 
Back
Top