Attn: AiW card owners

x10

Gawd
Joined
May 9, 2002
Messages
794
I was wondering if anyone knew if there is a way to force the ATI All in wonder card to output to either rca or svideo. My card only outputs if it is connected to the tv or vcr, however if i connect it to only my little 5" lcd with rca inputs i get no picture. Before you ask, the lcd does work perfectly, its just that the card must not be getting any feedback...

anyone who can help me, please help me...:)

thanks

.:[x10]:.
 
You can buy cables for this at ATI.com. I own an AIW 9800 pro, it came with the s-video/rca output cable. It also came with the hd-tv output cable. You can pick both of these up at ATI.com from the accessories store.

ATI Accessories
 
Sounds like the resistance load your LCD is putting on the wires isn't enough for it to decide there is something connected. Try potentially putting a resistor in series with the LCD.
 
i'm having this problem too, supposedly with cat's 3.8 and higher(though i could be wrong with the numbers) there is an option to force the signal to be sent.

I have yet to try this, because i'm rock solid with pre-cat drivers and don't see any point in messing with it. When i move out of the dorms and get a real tv i'm going to have to try it, so let me know if you get it to work.

btw, i have an original aiw. good luck
 
Go in the display tab of your ATI control panel.
You should have a "Troubleshoot" button.
Click on it.
You will have a check box for "Force Tv detection"

And voila.
 
ok last night i happened to come across the force output option but here's the thing: The LCD is goiong to be the only monitor since it is going to be used as a carputer. So when you force the detection u still have to use the primary monitor to enable the lcd.

Can someone explain what i could do to this lcd so that it could work? Where would i put a resistor?

any help would be appreciated...
 
Originally posted by Cryect
Sounds like the resistance load your LCD is putting on the wires isn't enough for it to decide there is something connected. Try potentially putting a resistor in series with the LCD.

could you elaborate? or someone else elaborate?
 
Originally posted by Cryect
Alright here is an article discussing what you need (btw was slightly confused with what you wanted before but makes more sense now)

http://modasylum.com/guides.php?guide=18&page=0

this will probably help as well, but what the problem is, is that the LCD isn't getting a picture from the card even when the VGA plug is in. Is there any help as far as putting a resistor on the RCA cable itself? or is it possible that the negative line is not properly grounded?
 
Back
Top