ATI 2900Pro GPU waterblcok recommendations?

K

Kenai

Limp Gawd
Joined
Aug 11, 2004
Messages
303
I couldn't wait for all the GPU wars to settle so I saw a deal on an ATI 2900 Pro 512bit/512MB card for around $159 and picked it up. This seemed to provide the most bang for the buck. I fully intend to flash and/or overclock to 2900 XT speeds once I get this guy broke in and my 8-pin adapter arrives. The one thing is that it is noisy, at least noisier than my old 7800 GT with the NV 5 silencer. I already have a Swiftech Apex Ultra H20-220 kit which has been running flawlessly for the last two years.

I am open to any suggestions on what people have utilized on their 2900Pro's. I do notice that Swiftech has the MCW60 that works on the 2900XT, which I believe is the same card? I would need an adapter kit, but that's no biggy.

What are other people running for their 2900Pro's?

Thanks for any help on this. Specifics can be seen in my sig below.

*edit* it appears I can't spell waterblock
 
Matti said:
though the d-tek is uber restrictive
you better have an insanely powerful pump or a dedicated gfx loop
Click to expand...

Got a Liang D5 Vario. Hopefully that'll be enough for the D-Tek GPU block, Swiftech Apogee GT CPU block, EK 680i LT northbridge block, and pushing through a Swiftech MCR-320-QP. All 1/2". Finally swapping over from my ghetto-rigged Aqua-Computer/Dangerden 6mm ID 8mm OD GPU-only monstrosity of a loop. (Just can't seem to pick a company I like, can I? :p)
 
You must log in or register to reply here.
Back
Top