I've only built/overclocked Socket A systems in the past ...but, I recently built a system using this board with the following.
1.) 3.0 ghz Cedar Mill.
2.) 2 sticks 256mb Geil 3500 sticks memory.
I set the FSB to 233 & the memory to 200 ...& it booted up at 3500 mhz without any increase in processor (30 C) temp.
I noticed while using the newest version of Everest ...that my Memory was running at 217 mhz & the memory/FSB divider was 6/8. I've always thought that it's better to run 1:1 or possibly 1:2. (Flexibility option is turned off)
Could someone please explain this memory/FSB divider thing for this board in detail using my setup with DDR & also if I switched to DDR2. I've looked elsewhere & could only find minimal info regarding this.
1.) 3.0 ghz Cedar Mill.
2.) 2 sticks 256mb Geil 3500 sticks memory.
I set the FSB to 233 & the memory to 200 ...& it booted up at 3500 mhz without any increase in processor (30 C) temp.
I noticed while using the newest version of Everest ...that my Memory was running at 217 mhz & the memory/FSB divider was 6/8. I've always thought that it's better to run 1:1 or possibly 1:2. (Flexibility option is turned off)
Could someone please explain this memory/FSB divider thing for this board in detail using my setup with DDR & also if I switched to DDR2. I've looked elsewhere & could only find minimal info regarding this.