Anyway to reset the bios manually

[cr3do]

Is there anyway to reset the bios manually i ran my overclocking passed stability and it wont boot to bios, so is there anyway to reset my bios manually

 

[mrgstiffler]

It depends on the board. A lot of BIOSes allow you to hold the Insert key at bootup, and it will use default speed settings...

 

[C@$H]

use the reset pin...?

 

[distr0]

if all else fails, rip the red ignitor button out of your barbecue, hold the metal tip up to your bios (i'm sure any part of the motherboard will do) and press the button. blamo, everything is reset!

this method actually works with almost all electronic devices

disclaimer: i am not responsible for any damage that WILL be caused

 

[FiZ]

Is there anyway to reset the bios manually i ran my overclocking passed stability and it wont boot to bios, so is there anyway to reset my bios manually

Yes clear the CMOS jumper, or just remove the battery for 10 seconds and put it back. Check out your manual to see how.

 

[cnick79]

When my bio wont load I simply pull out the power cord and plug it back in and voila! Failsafe.

 

[MikeP]

Yes clear the CMOS jumper, or just remove the battery for 10 seconds and put it back. Check out your manual to see how.

Yes as above^^^^. Clear CMOS will reset the bios. Just unplugging the PSU shouldnt clear the BIOS, thats messed up or maybe a dead battery.

 

[Toad21]

Check your manual for the Jumper that is located on the motherboard that will reset your bios. That or take out the battery for 20 seconds, make sure everything is unplugged, then put it back in.

-Answer

 

[cr3do]

Hmm i tried out the battery method and still got no results still wont load :X