Anyone know where to get circular cable grommets?

S

Smoblikat

Limp Gawd
Joined
May 28, 2020
Messages
444
Hello, im trying to find a half inch cable grommet with the triangle teeth, but I havent been able to find anything like what im looking for. This is an example of what im trying to find:
haf912puls_g4-zoom.png

That little tiny one on the side is a bit too big for my needs, but its not far off (I do have a HAF 912 I could "borrow" from if need be). It just needs to be big enough to fit a 4 pin fan cable through, which I believe is about .4 inches.

I appreciate any help you can provide.
 
That is the back of a Coolermaster Haf 912 case or a Enforcer case both collectors items according to ebay.
 
Smoblikat said:
Good call, I was able to find these:
https://www.primochill.com/products/primochill-1-2-inch-cable-tubing-rubber-pass-thru-grommet

But they dont have the triangle flaps that im looking for :/
Click to expand...
not sure if youll find ones that small with "teeth", usually those are 3/4" and up.
edit: might need to get "closed" or "blind" ones in the size you need and cut your own "teeth"
https://www.ebay.co.uk/itm/Rubber-G...osed-Grommet-Plugs-Bung-6mm-50mm/262281562555
https://www.amazon.ca/PV510M-Grommet-100-Diaphragm-Polyvinylchloride/dp/B07QJWYNKM
 
Last edited:
As an Amazon Associate, HardForum may earn from qualifying purchases.
Amazing, thanks for the help, i was able to find an ebay store with a whole bunch of sizes to pick from. Im going to get the solid ones and then just cut my own triangles into it, that should work out well.

https://www.ebay.com/itm/352379375471?hash=item520b728f6f:g:mW8AAOSweRlasn1f

GB12 is 12.3mm, which is just under half an inch, so that will work out great as I think I only need .4.
 
As an eBay Associate, HardForum may earn from qualifying purchases.
As an eBay Associate, HardForum may earn from qualifying purchases.
You must log in or register to reply here.
Back
Top