Any bios change = no post

the@ntipop

Gawd
Joined
Sep 27, 2002
Messages
609
Alright so I decided to Shuttle a second chance and upgraded my old SN41G2 for a new V2. I put in the same components as below and had to reset the CMOS using the jumper to get it to post. Kinda weird. However I wish that was the worst of my problems. Now, every time I answer 'yes' to the question "Save to CMOS and exit?", the box will not post. It does have a mobile Barton in it, but that shouldn't be a problem. It certainly wasn't on my first Shuttle.

Now what I don't get is how a single BIOS change can cause a box not to boot. I've never seen this in any other board, nor have I heard of it in my time on SFF forums. It doesn't matter if it's a chip clocking option or simply disabling the onboard video. In fact, the only option in the BIOS I've been able to successfully change is to tell it there is no floppy drive. Anyone have any ideas? I've had it suggested that it could be a bad battery. Thanks for any ideas.
 
The Nforce2 chipset boards are notorious for flaky problems with the BIOS. People had had lots of problems with ALL boards with this chipset and BIOS SAVE AND EXIT. Do a Google search for NForce2 Dead BIOS and see.

Check your battery certainly. A new hot battery should be 3.3v, anything below 3v replace it, they're only about $3 anywhere.

Low batteries can cause weird problems. I just worked on a freinds system and couldn't get it to recognize a new hard drives paramters using the AUTO DETECT settings until I put a new CMOS battery in it, then no problems.

Replace the battery first. Then from now on SAVE wait about 10 seconds and then SAVE AND EXIT.

Also with ANY board these days (except a Gigabyte with dual BIOS) especially any Nforce2 boards, an IOSS BIOS Savior is a very wise investment.
 
Back
Top