another BIOS released for DFI Infinity NF2

I'll have to give it a go...

Got it installed, but now it takes forvever on start up to see the hard drive. It sits after verifying the ram and does nothing, then bam there is the hard drive after maybe 10 seconds. Used to be almost instant.

Boosted my mem scores a bit tho from high 29xx to 3015.
 
Turns out there is a HDD delay feature... I just had to set it to 0 from 12 seconds.

Wierd.
 
hey i got a question does the infinity support mounting hole heatsinks like the sp-97?


also what are the quirks with the board ie is it willing to run at command rate 1T, overvolts, undervolts, etc.
 
Yes it thas mounting holes...but you need to install heatsinks like the SP-97 VERY carefully. A few guides at amdmb>DFI section on how to do it right.

It overvolts

...and Command Rate is CPC i believe. Options are to enable or disable. Disable allows double sided dimms to OC alot better than they normally do.

Quirks? It's slightly slower in 3dmark01 than say, compared to a NF7-S (according to some people). It is definitely FASTER than my 8rda+. Oskar_WU is working on it...it has something to with AGP latency i believe.
 
ok i am at 2.5 GHz and its not prime stable but i can run benchmarks and play games.


am i not feeding the northbridge nuff voltage or the cpu or what?
 
what FSB? multi? current volts?

Increase the NB volts all the way up to 1.75v
 
to install the SLK/SP bolt-thru heatsinks, please contact support@thermalright.com and tell them which board you have, and they should supply you with the new backplate to correctly mount these heatsinks to the Infinity/LanPartyB boards.

NB (if you have good case airflow) can be ran at 1.9v without problem for most people (I always set mine to 1.9v when overclocking)
 
Back
Top