AN7 - Onboard lan cuts out.

Roach

Limp Gawd
Joined
Apr 30, 2003
Messages
467
Ok, I've been using this board for awhile and overclocking has been good. Now though after 10 minutes the lan will cut out and I have to restart to get it to work again. It first started when I was doing 222x11.5... So I turned it down to 220x11.5 and that seemed to solve the problem. Now its back again, so I tried stock mobile speeds, samething. I haved tried multiple bioses with no improvement, so I finally popped a 3com 10/100 NIC in and that seemed to fix the issue.

I really liked the onboard LAN feature of this board and I hate having to have an extra PCI card in my computer. Is there anyone that has had a similar problem and been able to fix it? I've tried every bios config I could think of but nothing is helping.
 
Update - Now onboard sound decided it wanted to join the party.

Dying motherboard?

Would increasing my northbridge voltage help at all?
 
The southbridge chip is probably overheating. Try adding a heatsink to it.
 
Good lord, I just touched the southbridge and I think you might be right. Any suggestions on a good heatsink and some adhesive compound? (No mounting holes) :(
 
i have the same mobo and my stock nb fan crapped out, i just replaced it with the copper vantec chipset cooling kit with no probs.. temps went down a bit compared towhat they used to be and very easy to install..
 
Yea, the Vantec Iceberq kit is perfect. It's what I put on my NF7-S, the smaller heatsink (copper colored aluminum) works great on the SB, just stick it on with the included thermal tape. Also the real copper HSF is a perfect replacement for the stock northbridge HSF and will cool a lot better than stock too.

from newegg

from SVC
 
Jake.LD said:
Yea, the Vantec Iceberq kit is perfect. It's what I put on my NF7-S, the smaller heatsink (copper colored aluminum) works great on the SB, just stick it on with the included thermal tape. Also the real copper HSF is a perfect replacement for the stock northbridge HSF and will cool a lot better than stock too.

from newegg

from SVC

Very cool, I have a Vantec Iceburg4 pro that I put on my northbridge with a little modding but has a very annoying blue led that doesn't go well with my other lighting so that would be a perfect replacement. The only thing is that I would have to switch the two pin connector with a three to fit the AN7 northbridge power connection.

Thanks for the post.
 
Roach said:
... The only thing is that I would have to switch the two pin connector with a three to fit the AN7 northbridge power connection.....

I think the AN7 has four 3-pin fan headers so you could just connect to one of those.
 
Back
Top