AN35N Ultra 400 IDE problem

Elixir

n00b
Joined
Jul 20, 2004
Messages
14
I just got my new AN35N Ultra 400 Rev 1.1 in yesterday and I can't for the life of me get it to recognize any IDE devices on the first channel. If I boot on the 2nd channel Windows immediately says, "We've stopped your system to prevent damage" but fails to give me an error code.

Does this sound like a defective mobo or what? Anything I should try before I RMA this back to NewEgg? I've swapped procs, psus, drives, and vid cards. I only have 1 stick of RAM so I can't that. All these parts work 100% in my K7S5A btw. The K7S5A just can't run at 133FSB for some reason (standard problem I'm told, I should have RMAed it when I got it).
 
If any drive is plugged in to the first channel it hangs on "Detecting IDE Drives" during the boot procedure. =(
 
If windows boots on the 2nd channel, but gives the stop screen, that sounds like your trying to use the version of windows from the K7S5A on the AN35 Ultra...which you cant do. Set it to boot from CD 1st, then the 2nd ide channel(your hard drive), install XP and see if that works.
 
Elixir said:
If any drive is plugged in to the first channel it hangs on "Detecting IDE Drives" during the boot procedure. =(

If you changed cables and chekced the HD's and even tried just a cd-rom on IDE1 then all you can do is reset the BIOS with the jumper then RMA. Sorry to hear if it is. I'm had the same board for so long without a fart running high FSB's that if it is bad.. give it a second chance.
 
I have never had anyproblems with this board (except for a FRIED bios when i set FSB to 205). Try usind a different hard drive with a new cable and the jumpers set to master on the drive. Also, check your ram timmings in bios. Run OCZmemtest86 to check for memory problems.
 
Back
Top