Am I too sensitive? - dust behind screen

Joined
Apr 19, 2008
Messages
14
Hello.

Story short:
I`ve had 3 NEC 20WGX2 Pro (cause I`ve RMA`ed 2 units). Every one had same problem.
With time passing, more and more dust gathered *behind* screen. On this NEC it was very visible (for me) due to glossy screen, and excepcional sharp image quality.
Then my younger bought newer monitor, so I`ve took his old NEC 1760NX. Guess what? - there is dust inside screen too. Not as much as in 20WGX2 but it`s there.
About 2 months ago I`ve bought myself HP LP2475W.
After 1 month use - I`ve noticed first new dust spot, and moment ago, two more dust-like particles behind screen. Very heavy AG coating causes, that this dust is hard to notice, but it`s inside LCD, and it was not there when I bought it.

Maybe I`m just too sensitive for this problem, or just my eyesight is too good? ;-)

Do all manufacturers do not seal inside of the LCD from dust getting in?

Regards,

PP
 
Wow that would be annoying. Is it an IPS thing? I can't see any dust on my TN. I'm sensitive to these things too. CRT's killed me, even with high refresh rates.
 
I own the NEC 20WGX2 and I've never had that problem.

If I did, I would not hesitate to RMA it.
 
It happens with all panels.

That's why I take them apart and seal them with masking tape, after blasting out the dust with canned air.

All monitors are basically assembled the same way, and it's easy to do if you have the guts and don't mind voiding your warranty. In any case, if you have a dusty environment, it's going to keep happening.

A Room Air Ionizer (Ionic Breeze, etc...) can reduce this, because it makes the particles stick together and therefor heavier, thus lowering the chance they will get under the film.
 
NEC 1760NX is TN as far as I remember.
Some time ago I had cheapo Benq 17` - that one did not had this dust problem.
I also used to have air ionizer in computer room, but I observed that when it was activated, more dust appeared "quicker" with time behind NEC 20WGX2 screen.

Do sealing with masking tape would not cause panel to overheat?
 
Is the room you are in very dusty? Perhaps you just need to clean more often! :D
 
I thought they were sealed. However, if a panel has vent holes or something, I would not plug them up...
 
Back
Top