I was wondering if anyone would think it possible to take an older (aka cheap) motehrboard and processor (K6 266 Socket 7 era) and mod the socket to extend it via small bundled wires in order to place it somewhere else in the case. This would involve soldering a wire to every pin on the processor and then locking the other end of that wire into the socket. Doing this could make for some cool mods. I was wondering if it would cause problems with either voltage drop and/or interference in between the wires. They would all be the same length/grade wire, probably bought precut from RadioShack like they sell for kits. I'd use the smae guage wire used in IDE cables for rough comparison. THey wouldn't need to be any longer than say, 9 inches.
Is this possible? I think it would be an extremely amazing mod.
If not hte processor, then how about an PCI or ISA slot... remove the slot and solder wires to move the slot some other postion in the case.
Is this possible? I think it would be an extremely amazing mod.
If not hte processor, then how about an PCI or ISA slot... remove the slot and solder wires to move the slot some other postion in the case.