Ok, so I had a bad board that I RMA'd. But the board they sent back seems to be even worse.
The first thing I've noticed is that the BIOS was from 12-24-2020, which obviously hasn't happened. So I tried to flash from a floppy, however it wouldn't get past the detecting IDE drives on the post screen. So I pulled out all the IDE drives and just left the floppy installed. When it went to boot from the floppy, it gave me a disk unreadable i/o error message.
So, I tried making a bootable cd and flashing with that and plugging in only the cdrom. This worked.
So I tried plugging in all the IDE drives again and its still hanging at "detecting IDE drives" So I unplugged them all except for the hard drive. Here's where things get tricky.
The hard drive motor won't spin up when the IDE cable is plugged in, however when the IDE cable is NOT plugged in, it does spin up. Furthermore it works on my friends computer.
Continuing with the problems, it will sporadically give me the Two-Tone Siren that supposedly means its overheating, but according to the temp monitor and thermal probes its only in the mid 30 c's.
Last night, after a load of fiddling, I did get it to boot into Windows of the drive, but lo and behold, its hanging at detecting IDE again.
I put bios 21 on it and I have a 160gb Maxtor if that means anything to anyone.
Thanks in advance
Chris
The first thing I've noticed is that the BIOS was from 12-24-2020, which obviously hasn't happened. So I tried to flash from a floppy, however it wouldn't get past the detecting IDE drives on the post screen. So I pulled out all the IDE drives and just left the floppy installed. When it went to boot from the floppy, it gave me a disk unreadable i/o error message.
So, I tried making a bootable cd and flashing with that and plugging in only the cdrom. This worked.
So I tried plugging in all the IDE drives again and its still hanging at "detecting IDE drives" So I unplugged them all except for the hard drive. Here's where things get tricky.
The hard drive motor won't spin up when the IDE cable is plugged in, however when the IDE cable is NOT plugged in, it does spin up. Furthermore it works on my friends computer.
Continuing with the problems, it will sporadically give me the Two-Tone Siren that supposedly means its overheating, but according to the temp monitor and thermal probes its only in the mid 30 c's.
Last night, after a load of fiddling, I did get it to boot into Windows of the drive, but lo and behold, its hanging at detecting IDE again.
I put bios 21 on it and I have a 160gb Maxtor if that means anything to anyone.
Thanks in advance
Chris