Abit NF7 power fan header.

Sanitarium

[H]ard|Gawd
Joined
Feb 3, 2004
Messages
1,080
I have an Antec Smart Blue 350 and it has a connector to connect to your motherboard's fan header to adjust it's fan speed according to your system's temp. Well I've connected it fine and everything, but when I go into AbitEQ to check it's fan speed it shows up as being off. Is this just a problem with AbitEQ or what? Are there any other programs that will monitor your power supply's fan speed? Thanks.
 
You don't need to plug it in, that is just to monitor the speed. The fan will adjust whether you plug in the header or not.

The reason it isn't giving you a reading though is because it will only read above a certain RPM, 1,500 I think for the NF7. If the fan is spinning below that it will just say it is off.
 
Back
Top