Abit KV8 Pro - Mobo Warping?

PoW

Limp Gawd
Joined
Mar 12, 2001
Messages
347
I saw this discussed elsewhere but was wondering if anybody else has run into this problem, When i secure my waterblock onto the mobo the motherboard apparently warps a bit. The result is that ram doesnt sit in its sockets very well so you have connection issues with the ram.

Anybody else heard of this problem or run into it yourself?

I had a kv8 pro and when i touched the ram it was hotter than all hell and with the slightest pressure applied when the comp was on would make the whole system start to restart over and over again in a real wierd erratic way.

After observing this over and over many sparks and much smoke came shooting out of the ram slots earning the board and ram a trip back to newegg for RMA.
 
how would a water block do such.. its in general lighter then a air cooler isnt it
 
believe it or not its just the force of the waterblock connected through the motherboard. The waterblock is pushing down on the cpu while pulling up on the holes through the mobo that its screwed into.

It creates a effect that if exaggerated resembles the letter M. Pulling up at the sides and pushing down at the middle if that makes any sense.
 
PoW said:
believe it or not its just the force of the waterblock connected through the motherboard. The waterblock is pushing down on the cpu while pulling up on the holes through the mobo that its screwed into.

It creates a effect that if exaggerated resembles the letter M. Pulling up at the sides and pushing down at the middle if that makes any sense.
lots... so you guys are overtightening the waterblocks
 
The warping problem is very real using any heatsink designed to spec. There is no accidental “over tightening” per say. You clamp on a factory HSF, rotate the lever to lock it and it pulls do hard on the screws that pass thru the board to the plastic backplate it cant help but warp the board. I had funky ram problems, I tried like 7 different sticks in a variety of combinations and some would work sometimes some wouldn’t. I had it boxed up and ready to RMA before I read about the warping. I ended up placing a block of acrylic under the motherboard directly under the ram. The motherboard screws pulled it back flat with the acrylic under the ram.

If you look close you can see the end of the HSF clamping screws passing thru the plastic backplate just under the word GURU on the box. The spaceing is very wide on the screws, and the clamping pressure is very high. Thats what is bending the board.
warped2.jpg

The bow is a little hard to see in the pic above, but look at the gold contacts in relation to the slot below.
warped1.jpg
 
ya thats totally what happened to me as well, while not quite as extreme as in those pics it still fried my ram.

Once I got my new ram and mobo i simply took much more care in mounting the waterblock, I haven't had the problem since however it is a bit worry some.

It probably doesnt make a difference but I at first had a v1.0 kv8 pro and after I rma'ed it I got back a v1.1 and its been perfectly fine. Again I doubt that has anything to do with it but its something to think about.
 
Back
Top