Abit IC7 dual channel ?

Voodooo

Limp Gawd
Joined
Oct 4, 2000
Messages
429
How can I verify if my memory is running in dual channel mode, besides benching ? cpu-z is reporting: channel # : single in the memory tab. The 2 sticks are same brand size and speed but they have slightly different CAS settings in the SPD and the chips and from 2 different batches.
 
What Dimm slots do you have them in? (should be 1 and 3, or 2 and 4)

Also, I think mine says "dual channel" while booting. (BIOS start screen)

==>Lazn
 
1 and 3 I'm not that dumb :) It certainly doesnt say anything about single or dual channel when booting !
 
I will double check when I get home, but I am quite sure it says: "1gb ddr ram in dual channel at 166mhz" or something to that extent. (yes, it is running slow, I still have a 2.4B not C in that MB)

==>Lazn
 
At boot up, it should show dual channel in the bios info. Your 2 ram sticks may not be compatible, thus no dual channel indication in Cpu-Z. Try to manually set the ram stick specs in bios so they run identical.
 
Certainly does not say anything in the post screen, except cpu type, memory test, and the frequencies for fsb, ram, agp and pci. Then it displays the drives, cdrom etc. I also placed the sticks in slots 1 and 2 and the scores are pretty much the same in the Sandra memory test, which is not good. I have them set to manual to get 2-2-2. Funny is that these sticks did work in dual channel on my old Epox nforce2 board !!!
 
If it doesn't show dual channel at boot up in the POST screen then your system isn't running in dual channel mode. Try and get two identical ram sticks and try again.
 
Hmm ive got an IC7 running generic PC2700 DDR. Have them in slots 1 and 3. It states its in 'Dual Channel' on bootup. Dont know what the problem is bro.
 
i have a max3 with ocz in slots 1&3....it tells me that i have dual channel mode when i post and am in the bios!!!!
 
Back
Top