ABIT AI7 PWM temps

BigTaf

Gawd
Joined
Aug 4, 2004
Messages
905
where is the PWM temperature sensor located on the abit AI7?

Having a weird problem here, I recently changed the Cooler on my Northbridge to an NB-1 by thermaltake. As well as did a few other cooling updates at the time (VGA Silencer, few panflos.

Now my PWM temp is up to 80c under load and I can never remember it going this high before. I do have a presscott 2.8 & 3.4 using 1.48v, but this is the same CPU I used prior to changing the northbridge.

any help would be appreciated
 
I'm not sure EXACTLY where it is, but it is located near the mosfets on the left and top side of the CPU socket. I added some small sinks to mine and a quiet 80mm fan mounted in the drive bay to move more air over them. I use a Northwood and the highest my PWM temps have been since doing that are 55-60c. With a prescott I would expect that to be 5-10c higher, but 80c??? I know that it's rated for "nominal" operation up to 170f (whatever that is in C, I'm too lazy to convert right now.)

If you added fans, try taking them out and going back to your original fan configuration. You may have had better airflow over the mosfets before and somehow changed it with the addition of fans.
 
nst6563 said:
I'm not sure EXACTLY where it is, but it is located near the mosfets on the left and top side of the CPU socket. I added some small sinks to mine and a quiet 80mm fan mounted in the drive bay to move more air over them. I use a Northwood and the highest my PWM temps have been since doing that are 55-60c. With a prescott I would expect that to be 5-10c higher, but 80c??? I know that it's rated for "nominal" operation up to 170f (whatever that is in C, I'm too lazy to convert right now.)

If you added fans, try taking them out and going back to your original fan configuration. You may have had better airflow over the mosfets before and somehow changed it with the addition of fans.

the pwn will get VERY hot using a prescott, especially with increasing voltage.

even with very good case ventilation 80 C under load with a overclocked prescott is normal.

as to why the pwm would change with a northbridge cooler change...im not sure...i don't know the exact location of the pwm sensor on the motherboard, but i thought it was up towards the top of the board around the mofsets...
 
oddly enough it seems to have taken care of itself.

doesnt seem to go above 50c now. very odd indeed as I didnt change a damn thing
 
Back
Top