A7N8X CPU upgrade problems

niaxous

n00b
Joined
Jan 31, 2004
Messages
8
ASUS A7N8X2.0 ACPI BIOS Rev 1003
Phoenix-Award BIOS v6.00PG
BIOS DATE 03/19/03
AMD Duron 800 Processor upgraded to
AMD Athlon XP-A, 2079 MHz (6.25 x 333) 2800+
Barton
FSB 166
multiplier: X12.5
Core voltage 1.65 V
Zalman CPNU 7000 Cooler (close to the power supply)
Elixir Memory 512MB DDR333 PC2700
300W Power Supply
1 Maxtor 40Gb HD
Freshly installed HD
Abit FX5200
Windows 2000 Service Pack 4




Hi,


I bought an new AMD 2800 XP Barton processor for my mobo but the system is not stable:(
All my games and applications are shuting down and the pc restarts.
I can use the internet and do receive windows errors
I set the memory timings of my Elixir Memory to default as mentionned in the Asus Mobo instructions but this made things worse, unable to boot the system => Clear CMOS and all was set back to default=> 7 3 3 2.5

I then tried to change the multipliyer to lower ones but this changed the FSB to 100 and the CPU was 1250Mhz and the POST would just freeze.
Reset it too 12.5 and the system boots up to Win2000 and the CPU would show AMD XP 2800.
I can't figure it out problem.

So, if you could help me in clearing this problem and stabalising the sytem I would be gratefull.
Thanks for your future posts.
Niaxous
:)
 
I would almost put money on the fact that your HSF is not seated properly and you are overheating the CPU.

What are you CPU temps after a few minutes of running in the BIOS?

I would almost guarantee you to start there;)
 
Thanks for your post.
I re-booted the system and entered the BIOS.
Checked the CPU temp at start-up => 28°C/84°F, after 2 minutes it was at 87°F and yes the temperature is increasing.

Could you tell me where I can locate this HSF, is it on the Motherboard or in the BIOS?
 
Did you run a previous system, with a different processor and chipset, with the same Windows 2000 installation as you're running now? That can cause problems with your new setup - big time.
 
No, it's the same system and OS.
I did however buy a AMD XP 2600 (FSB 133) but was rather dissapointed of the performance.
The store agreed to change the CPU for the new Barton XP 2800.
It got unstable when I installed the second CPU and it got worse with this one.
The system just re-boots after a while.
 
Format and reinstall the OS.

After that, my guess would be crappy RAM.
 
This would be my last option and yes it would solve it but
I am sure there is another way to solve this problem.
The system hasn't re-booted for the last two hours.
It's 5.30am and I am about to fall asleep.
Thanks for your post
 
HSF = Heat Sinck Fan?
So I need to replace this, I'll give this is a try because the salesguy stressed hat could give me too many problems if it was too close of the power supply.
With it's 90mm diameter fan, it almost touches it.
I will give it a go and start from there.
 
if it's possible, can you post pics, we might be able to see phsycially whats the problem
 
Back
Top