4x1TB raid 5 shows as 2tb??

[TYPE]SS

Limp Gawd
Joined
Aug 2, 2001
Messages
438
Just installed 4x1tb on rocketraid 2310 on windows server 2008 as NAS for my business. After setting it up as raid 5, raid management software tells me it has 3tb but when i try to format under windows, it shows as 2tb. Does anyone know why? And is there any solution for it?
Thanx guys
 
You can only use volumes over 2TB in size in Windows with GPT partitioning. That's the only way Windows can see the whole size.

Now, bear in mind that you CAN'T boot windows from a GPT partition unless you're using UEFI as your boot manager (AFAIK, only MSI has a couple of UEFI-based motherboards, everything else is still using only BIOS).

Cheers.

Miguel
 
I'm not familiar with the way Windows handles volumes, but I think you have to set it as a GPT volume. NTFS itself has no issue with large volumes, but I think legacy code in a modern BIOS does.
 
im using this as a storage drive only so i'll set it as a GPT volume and just grab another drive to run the system.
thanx guys~
 
NTFS itself has no issue with large volumes, but I think legacy code in a modern BIOS does.
Yes, the problem is the BIOS, 2TB is the largest addressable HDD area using BIOS/LBA to access HDD information.

The result is, drives/volumes over 2TB can actually be seen as n-2TB in size by the BIOS/OS if GPT is not used. Just read about the new 3TB drives being launched and you'll see the BIOS is all over the place with them, often only under 1TB being revealed to the OS using LBA.

This is starting to become a problem, with multi-TB consumer HDDs right around the corner. I hope most manufacturers make the switch to UEFI ASAP (a BIOS-compatible mode is still available for compatibility, btw), so users won't end up hitting walls just wanting to install Windows on a large drive...

Cheers.

Miguel
 
Back
Top