20" iMac Hard Drive Replacment

BootSector

Limp Gawd
Joined
Aug 12, 2004
Messages
165
This morning when I woke up my iMac, it had the spinning beach ball of death. Nothing responded to the mouse or keyboard commands so I held the power button and rebooted it. After rebooting it was still slugish and I could hear the hard drive reading data when previously the machine had been dead silent. I am thinking it might be time for a new drive?
 
I just did one of these, I'm assuming you are talking about the white plastic one, not the newer 21.5" metal one?

You need a special tool to get the front panel off. Basically you undo all the screws at the bottom, pull up on the stand to crack the bottom loose, then the front panel will start to come off. At the top of the front panel by the webcam is where you need the tool. There's 2 metal clips that have to be depressed at the same time to get the panel off. You might be able to just work them off by poking around at them. I actually just ripped the one I was working on off because the computer was garbage.

Disconnect the webcam, IIRC there's 2 wires for it, then the front panel will come off.

Now you can see the LCD and all the shielding. You will have to pull back all the shielding around the edge of the LCD to find all the torx screws. IIRC theres 6 or 8 of them, should be pretty obvious to find. Once you get all of them out the whole lcd assembly will pull forward.

You should have enough room to set it aside and still be plugged in. You will clearly see the HDD at this point and should be pretty obvious on how it comes out etc.

edit:

pretty much like this for the bottom screws

http://www.youtube.com/watch?v=1tt8Jky3RQY

I forgot about the screws that don't come out all the way.
 
I did my 24" iMac not too long ago, although it is an older Al model.
The basics of it is that you have to get a couple of suction cups to pull the glass in front of the screen off. The Al front will then unscrew and you will take it off after unplugging the camera cable. Then you will have to unscrew the screen and carefully unplug a couple of cables before propping it up. At this point you should be able to get to the HD easily to swap it out.
The biggest pain was trying to clean the glass before I put it back on so that there was no dust.

The easiest way is to go to http://www.ifixit.com/Mac-Parts/iMac-Intel-20%22 and click on your iMac model. You can then click on the 'Step by step guides' on the right side of the page. Then click on the 'hard drive replacement' guide and they have a really nice step by step of the installation process.

Just remember to do it on a clean surface and keep your screws organized and it is fairly easy.
 
Back
Top