Recent content by Xenner

Napp-it showing 11tb total space, 9tb useable. ZFS list shows 7.84TB if you add used and available.

Ok, aquired two new drives, going to re-do this all with RaidZ1 Is this kosher -- only drives I have right now: 3x2tb Seagate 5900rpm Green 512b 1x2tb Seagate 5900rpm Green 4k 1x3tb Seagate 5900rpm Green 4k Have them in a RaidZ1, actually showing about 9TB usable space...it is using the whole...

I'm somewhat back up and running but this new disk is a Seagate S2000DL003 4k sector disk. My other 2TB's are 512b ST32000542AS I cannot add it back in because of sector alignment... cannot attach c2t5000C500370C382Bd0 to c2t5000C50029ECDE52d0: devices have different sector alignment Help!!

Crashing and burning now -- getting write failures on boot (no space left on device) I have changed nothing on the boot drive which is an SSD...

Now I booted back up and it is showing my one good drive in that array as faulted and "corrupt" is that because it's mirror dissapeared?

drive was pulled out of system

Have 2 Mirror'd vdev's inside a Pool, drive has failed on one. I marked it as removed and now inside my pool I have one mirror and another device standalone. I cannot seem to add this new drive back into a mirror with the now standalone drive that was previously mirrored. How do I do this...

having an issue with this setup. If I write a file via SMB, I can't read/access it via NFS. I am assuming this has something to do with the default SMB settings in napp-it and the ACL maps...?? What the the easiest, most direct way to fix this?

So that would be two different vdevs? I would just add them to the same pool and it would act exactly the same??

Guys, Putting the finishing touches on my ESXi/ZFS box. I have it up and running with 3x2tb Seagate drives (got them on Craigslist for $70 each still in warranty, can't beat that price.) Problem is for me to get a 4th, it would be ridiculously expensive. I do have a 1.5TB Samsung drive...

Just was looking for something with a higher MTBF than a platter hard drive...thought about doing it from a CF card or USB key...

After researching for a while on where I should migrate my storage to here is what I am thinking of. I am looking to go with _Gea's guide of the BSD, ESXi combo. Old box - HP Mediaserv EX470 w/ a total of 2tb storage. Purchased so far. Xeon E3-1230 Tyan S5512WGM2NR (Onboard LSI 2008) 8GB ECC...