You will need to be more specific than that, as you have probably just described half to three-quarters of the people at Ground Kontrol at any given time.
And me, for that matter.
To me, this looks like someone has been aching to wear some Town & Country Surf Designs stuff from the 1980s, but is too cheap to buy the legitimate deal.
I was not aware that the clothes I wear while doing nothing of any consequence could get any more comfortable than they are, and I think...
I was in Enterprise QA until 2006 in Beaverton. Consistently mismanaged and looking to waste $100 to save pennies, they never seemed to me to have any real clue as to what direction the industry was going, and were consequently always playing catch-up to the competition, even when the McAfee...
Yes, sorry... Thanksgiving has absorbed a lot of my time since last week, so I have not made much progress.
My connectors are in, and I am getting a LOT better at crimping those tiny buggers.
I haven't taken any pictures, just imagine yourself swearing at a crimper, some pins and a...
I ended up ordering the pins and connector I need from an online vendor, as the "electronics supply" place across town does not stock the parts I need.
So... yet again, I am waiting on parts.
I must confess at this point that I -still- have not made the 8-pin to two 6-pin PCIe cable I...
Check this out:
I am 90% finished with the build. As I said in previous updates, I still need to run to the specialty electronics store across town and get the pins and connector I need to connect the bottom fan (not pictured today) to the GPU's fan header.
Also:
More to come!
O callou callay! I met the mail carrier at the door, and he handed me the solution to all my problems.
Well... Okay, it was a box with a heat exchanger in it, not the Philosopher's Stone.
But it does solve my biggest problem to date. To wit:
Gaaah! The horror!
That is one ugly stock...
Those are custom-ordered, specially-cast one-off caps made from myrrh by the finest Chirobistan craftspeople.
I kid, I kid... they are 1 inch / 2.5cm nylon caps from the hardware store.
My local (Westmoreland TrueValue) had them in black or white nylon and a couple other materials.
Any...
I am sourcing a connector to replace the stock PWN plug on my big fan with the one on the card, so that the card can control the fan speed.
Mostly, I need to make some time to get to the electronics supply shop on the other side of town.
And so, I finished Season 6 of Corner Gas and didn't finish the build yet.
So, then... on to Season 19 of Top Gear, and some progress:
RAM in place and cable goodness:
From the back:
And cleaned up the other side:
You may have noticed that the fans are missing... yes...