Recent content by Stromer

  1. S

    Benchmarking problem, GPU and RAM

    Thank you very much for all your contribution. I look at this last point with 1.1V asap
  2. S

    Benchmarking problem, GPU and RAM

    Some results tend to give a 3200 MHz (memory section, windows 10), and some not (SPD section, userbenchmark) Hard to know if it really works as it should
  3. S

    Benchmarking problem, GPU and RAM

    Good question, I have that: And in Windows performance:
  4. S

    Benchmarking problem, GPU and RAM

    Looks like a clear CMOS. What are the other effects of it, do I loose my fans curves ect..? Interestingly, my RAM is not in the QVL of my MB! :banghead:
  5. S

    Benchmarking problem, GPU and RAM

    DOCP is selected and "accepted", the PC boots normaly, but looking at the CPU-Z I notice that the frequency is only at 2132 MHz
  6. S

    Benchmarking problem, GPU and RAM

    As expected, ver 8.31 on slot 2&4 only gives Nothing on Slot 1&3 Slot 2: Nanya single Slot 4: Nanya single Low performance, still 2132 MHz Note: in the meanwhile I solved the problem of the GPU benchmarking: I had to deactivate "Nahimic service" So for now only RAM issue remaining
  7. S

    Benchmarking problem, GPU and RAM

    With ver 5.22 in slots 2&4 this time I have something consistent on CPU-Z: Nothing on Slot 1&3 Slot 2: Hynix dual Slot 4: Hynix dual DOCP enabled but still low performance (even with DRAM voltage 1.4V) Now I can try the ver 8.31 on slot 2&4 and see what happens. As soon I do a mix on the 4...
  8. S

    Benchmarking problem, GPU and RAM

    I have an Asus B550F-Gaming Rog. According to CPU-Z strictly, it would mean something not logical: Slot 1: Hynix = ver 8.31 Slot 2: Nanya = but is also ver 8.31 Slot 1: Hynix = ver 5.22 Slot 2: Nanya = ver 5.22 Unless there is a problem in CPU-Z order But neither the combinaison...
  9. S

    Benchmarking problem, GPU and RAM

    Thanks. It looks a little bit complicated with Corsair Ram and Ryzen CPU.. Now I switched stick 2&3. So I have the same information slot1=slot3=SK and slot2=slot4=Nanya in CPU-Z. However the references directly written on the sticks are different! I have slot1=slot2=ver8.31 and...
  10. S

    Benchmarking problem, GPU and RAM

    Ok, thanks. How do I check if the 1.4V is better than the 1.35V without using userbenchmark? I made a CPU-Z and have following results, it seams that the RAM sticks have some different characteristics, even if they had the same reference where I bought it: Slot 1&2: Nanya ranks "single"...
  11. S

    Benchmarking problem, GPU and RAM

    Oh, yes, the benchmark I did is here: https://www.userbenchmark.com/Software How do you know what is the safe voltage for the corsair?
  12. S

    Benchmarking problem, GPU and RAM

    Dear community, I tried to benchmark my Asus configuration. I have: Ryzen 7 3700x GTX 1070ti Ram Corsair 4*8 Go Samsung 970 Evo+ I got following results: There is apparently a problem with the GPU and the RAM in this bechmark. However I have no problem to play games. I searched on...
Back
Top