Recent content by sonicz

I managed to get most of my important data saved, lucky me :) Now I'm gonna make a new raid, but before I do this I wanna aske if its possible to do the following and if its a stupid approach: 1. Disks are cleaned out. 2. Making a new raid 6 array. 3. Partition the array with parted. 4...

Solved

Hi All I have a M1015 flashed to 9211-8i in IT mode with firmware 15.00.00.00-IT. Connected to backplane in my SC846. When I boot without the cables plugged in there is no issues. When I plug the cables the controller takes FOREVER to find the disk (often it just keeps searching). But...

Hi all I'm not sure this is the right subforum. I have purchased a Supermicro SC846, and thats really nice and all. But now i'm Building my old server into the cabinet and stumbles on a issue, I hope someone have a good idea on how to solve. The Supermicro does not use the standard...

Managed to get access to my data with 5 disks. So for now im gonna Work on damage control :) Thanks for your reply.

I managed to get most of my important data saved, lucky me Now I'm gonna make a new raid, but before I do this I wanna aske if its possible to do the following and if its a stupid approach: 1. Disks are cleaned out. 2. Making a new raid 6 array. 3. Partition the array with parted. 4...

Was just me making a mistake, I deleted everything before writing formatwithmbr. So a fault 40 :)

Problem solved :D

I have now tried it, and seemed like I got a bit further, I could connect to it after installation, for downloading tools (couldn't that before), but after a boot it is the same again ;( Jumps into BIOS

Thx alot!! I Will try this when I get home :)

Hi All I'm having alot of trouble getting my ESXI host to work. My HW: XEON 1230-v3 Asus P9D WS MB with C226 intel chipset. I can install ESXI, no problem, but I can't boot it. Not getting any errors during installation or boot. Just a black screen untill it enters my BIOS. VT-d...

Sounds to me like xfs is not very raid capable then? - or can you change these values without wiping the disks? - Because I'm currently using 5 disks, but will grow 1 by 1 until around 10 disks and then the values will be off again?

can someone please tell me what I'm doring wrong here :) I added the fourth disk and did go well. I made sure to update the mdadm.conf and double checked that it had updated. When I booted it had thrown the new added disk out of the raid? - Can someone tell me what I am forgetting here? - I...

I umounted the mountpoint I have in fstab

Heres a update: I've decided to go with xfs. Yesterday I made a raid 5 array with 3 disks. Afterwards I made a grow with one disk, just to check if it would go well. And it did. But.. Everything looks fine except when I try to run a check on the filesystem: xfs_check -f...