Some users have recently had their accounts hijacked. It seems that the now defunct EVGA forums might have compromised your password there and seems many are using the same PW here. We would suggest you UPDATE YOUR PASSWORD and TURN ON 2FA for your account here to further secure it. None of the compromised accounts had 2FA turned on.
Once you have enabled 2FA, your account will be updated soon to show a badge, letting other members know that you use 2FA to protect your account. This should be beneficial for everyone that uses FSFT.
Ok here is what i have so far:
Fittings:
10 x EK Perfect Seal Compression Fitting 1/2" ID, 3/4" OD
GPU WaterBlock
(not 100% sure these work with Asus Direct CUII GTX 580's)
2 x EK Full Cover VGA Block EK-FC5X0 GTX GW Acetal+EN Nickel
Pump:
LAING DDC-PUMP 12V DDC-1PLUS 18W
Reservoir...
Thanks caniba.
I will do the CPU. Currently have the H70 installed but im pretty sure the actual water cooling system will perform much better?
Probably not on the chipset, unless its more important than i realise?
Wont be going insane on the overclocks but will push it a little.
Considering this pump: http://www.frozencpu.com/products/6190/ex-pmp-54/Swiftech_MCP655_12v_Water_Pump_w_Speed_Control_and_38_Conversion_Kit_317_GPH.html?tl=g30c107s153
2x...
For now i will cool only the GPU's. The cpu has H70 cooling on it and i will upgrade that in the near future most likely.
i have two Asus GTX 580 Direct CU II GPU's.
I have quite a few fans that are all very good.
The case is the 800D
Thanks for everyones help.
Everything is running very well and quite cool but with BF3 around the corner i want to push ultra with full FPS and the system has so many fans i would like it a bit quieter.
Water cooling.
Ive been doing a fair bit of research. It turns out i believe i need...
The computer is running very well.
I have the first 580 CU II in slot 1 and the 2nd in slot 4.
Both run very cool. I am reading about this ND200 chip that allows the boards to run at 16xs.
Currently they are running 16x and 8x. Any one have more information on this board or a link full of...
Thanks for the replies everyone.
Have just purchased installed and updated fully the extreme z motherboard.
Now time to benchmark and test the heat difference.
Have also purchased two new fans to try and pull alot more intake into the case.
Top GPU currently at 82 degrees with full stress...