:D Problem solved!!! The KingWin enclosure (either the enclosure's pass-through cable or the eSATA cable) was bad. RMA'd the KingWIn enclosure and purchased the Icy Dock MB559US1S and I'm blazing with hotplugged eSATA!!!!!!!!!!!!. :D
I took care of the boot partition problem by temporarily disconnecting my pri (internal)SATA drive's data connector, plugging in my WD drive internally, booting up with the WinXP install CD, and using its partitioning/formatting program to delete the WD O/S (boot) partition and formatting the...
Of course, the enclosure could be the problem, but I'm not sure how to go about trouble-shooting it. Perhaps the eSata data cable is bad... that I can check. BTW my WD drive (the one in the enclosure) does contain a WinXP boot partition from when I used it as the primary drive in my previous...
Yes, the case has a separate DC power supply with ON/OFF switch and is grounded. When I hotplug, the computer either (1)reboots or (2) remains OS stable with the drive sounding like it is trying to communicate. In the latter case, the drive activity light on the external drive case is...
What (program) is giving your temp readout? ASUS Probe is notoriously unreliable. Try Core Temp or Intel TAT . Probe reads as much as 18C higher than either Core Temp or TAT on my P5B-E with E6400 under load.
I'm trying to get my (formatted, partitioned) WD1600JD SATA drive installed on my eSATA port as a backup (non-RAID) data disk using a Kingwin eSATA enclosure, but the system keeps rebooting. My primary boot drive is a Maxtor 7H500FO SATA connected to internal (Intel) SATA-1. The JMicron...
If you haven't already purchased an OEM cpu why not go boxed with the stock HSF which is more than adequate? An OEM (unboxed) costs about the same with no warranty and no HSF. BTW, in many if not most cases, and overclocker reaches a mem limitation before a temp limitation. Anyway, there is...
More O/C temp confusion... I'm running a c2d E6400 stable at 3038MHz with stock fan/sink on an ASUS P5B-E (rev 1.01G) with the following cpu temp readings- Orthos(Idle): TAT=26C, CoreTemp=23C, Probe2=44C; Orthos(blend-stress): TAT=51C, CoreTemp=52C, Probe2=70C. Any theories as to the large...